In the box of Guider 3 Ultra series, we have configured some small accessories for the convenience of users. Here is a brief description of these accessories:
1.
Description: PLA Filament
Application: Material for printing models
2.
Description: Flexible Steel Sheet
Application: When printing ABS filament, this helps with the first layer adhesion, reduces warping,
and improves the print success rate.
3.
Description: Diagonal Pliers
Application: Tool for cutting filament during filament change
4.
Description: Grease (lubricant)
Application: Used for maintenance of lead screws and guide rails, reducing friction
5.
Description: Glue
Application: Applied to the build surface to enhance adhesion
6.
Description: Nozzle Kit
Application: Spare 0.4mm nozzle kit, for replacing the original nozzle kit when it is damaged
7.
Description: USB Flash Drive
Application: For model storage and firmware upgrades
8.
Description: Unclogging Pin Tool
Application: Tool for cleaning out the nozzle in case of clogs
9.
Description: Allen Wrench Set
Application: Used for maintenance and disassembly of the extruder, etc.
10.
Description: Tweezers
Application: For cleaning supports in tight spaces
11.
Description: Scraper
Application: For removing filament residues and models from the build plate
12.
Description: Straight Screwdriver
Application: For disconnecting the heated bed heating cable from the motherboard
Note: For your safety, please power off before doing so and contact a professional if necessary.
13.
Description: Needle-nose Pliers
Application: For cleaning supports or repairing equipment
14.
Description: Heat Resistant Gloves
Application: Wear when replacing or repairing the nozzle assembly to prevent burns
15.
Description: Fuse
Application: Backup fuse for the 3-in-1 switch, for replacing a damaged one
16.
Description: Brush
Application: For cleaning waste from the extruder gears or dust from the machine
